beautypg.com

Choosing the dial mode setting the language, Choosing the dial mode, Setting the language – Radio Shack 43-3857 User Manual

Page 10

background image

Installation

10

4. Use the number keys (

0

to

9

) or

CH/DELETE

to

enter the three-digit area code.

Ô

5. Press

REMOTE/SELECT

. A confirmation tone

sounds and the displayed area code is entered.

6. Press

END

or return the handset to the base

unit to complete the setting. The handset
returns to the standby mode.

Choosing the Dial Mode

Most phone systems use tone dialing which sends
standard tones through the phone lines. However,
some phone systems still use pulse dialing such as
in rural areas. The default setting is tone dialing.
Depending on your dialing system, set the mode as
follows:

Ô

1. When the phone is in the standby mode, press

and hold

CID/MENU

.

2. Press

VOL

three times to select

Dial

.

3. Press

REMOTE/SELECT

to toggle between

Tone

and

Pulse

.

4. Press

END

or return the handset to the base

unit to complete the setting. The handset
returns to the standby mode.

Setting the Language

1. When the phone is in the standby mode, press

and hold

CID/MENU

.

2. Press

VOL

four times to select

Language

.

3. Press

REMOTE/SELECT

to select from

Eng

(English),

Fr.

(French) and

Esp

(Spanish).

4. Press

END

or return the handset to the base

unit to complete the setting. The handset
returns to the standby mode.

Ô

NOTES

Ô

Entering your Area Code
When the area code has
already been stored in
memory, the stored area
code will be displayed. To
change it, use the

CH/

DELETE

and number keys

to enter the new area code.
Then press

REMOTE/

SELECT

. A confirmation

tone sounds.
To complete the setting,
press

END

or return the

handset to the base unit.

Choosing the Dial Mode

Make sure your battery
pack is fully charged
before choosing the
dialing mode.

If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave the
setting as is, otherwise
set for pulse dialing.

If your phone system
requires pulse dialing
and you need to send
the standard tones for
certain situations during
a call, you may “switch-
over” to tone dialing
(Refer to “Tone Dialing
Switch-over” on page
12).

43-3857.book Page 10 Wednesday, February 18, 2004 12:40 PM