Radio Shack 43-3857 - Manual (Page 12)

Operation
12
A
DJUSTING THE
H
ANDSET
R
INGER
AND
E
ARPIECE
V
OLUME
Handset Ringer Tone and Volume
Press VOL or VOL repeatedly in standby mode
to select one of five ringer tones and volume
combinations.
Earpiece Volume
Press VOL or VOL repeatedly during a call to
change the earpiece volume of the handset. This
setting will remain in effect after the telephone call
has ended.
Ô
Temporarily Mute the Handset Ringer
If the handset is off the base, simply press END to
temporarily mute the incoming ring. The ringer will
sound with the next incoming call.
R
EDIAL
The PAUSE/REDIAL key redials the last number
dialed. The redialed number can be up to 32 digits
long.
T
ONE
D
IALING
S
WITCH
-
OVER
Some telephone companies use equipment that
requires pulse dialing (sometimes referred to as
rotary dialing). If you need to enter tone dialing
digits, you can switch-over to tone dialing during the
call. For example, entering your bank account
number after you have called your bank.
Ô
Initially make your call with the pulse dialing mode.
Once your call connects, press
/TONE/< . Enter the
desired number. These digits will be sent as tone
dialing. Once the call ends, the tone mode is
canceled and pulse dialing mode resumes.
Ô
NOTES
Ô
Earpiece Volume
When you press
VOL in
Maximum mode or VOL
in Low mode, an error tone
sounds.
Tone Dialing Switch-over
•
The tone feature only
applies when the dial
mode is set to pulse.
• This special number can
be stored in a memory
location. This is referred
to as Chain Dialing (See
“Chain Dialing” on page
17).
43-3857.book Page 12 Wednesday, February 18, 2004 12:40 PM