RCA PSVR65 - Manual (Page 8)

6
Hooking Up the VCR
Position the Receiver
Position the receiver above the VCR. You may
need to position it at different angles before the
VCR can control it. Make sure the receiver does
not cover the transmitting window on top of the
VCR.
Do not stack electronic components or other
objects on top of the satellite receiver. The slots on
top of the receiver must be left uncovered to allow
proper airflow to the unit. Blocking the airflow to
the unit could impair performance or damage your
receiver and other components. Also, do not stack
the satellite receiver on top of a Òhot componentÓ
such as an audio power amplifier.
Basic Hookup
Use this hookup if your TV does not have
audio/video jacks.
1. Set the CH3 CH4 switch on the back of the
satellite receiver to either channel 3 or 4.
You will tune the VCR to this channel or its
line input
(L1 ) to record from the receiver.
To watch the satellite receiver, turn off the
VCR.
If you want to watch or record the signal
from your antenna, cable, or cable box, make
sure the satellite receiver is turned off.
2. Set the CH3 CH4 switch on back of VCR to
either channel 3 or 4.
You will tune the TV to this channel and use
the TV¥VCR button to watch the VCR.
3. Connect as shown.
This connection may require additional
accessories not provided.
4. Plug in power cords of VCR, TV, and
receiver.
5. Go to page 9 for VCR setup.
Caution: The unauthorized recording of satellite
broadcasts, television programs, or other materials
may infringe the rights of others.
Digital Satellite Receiver
CH 3 4 AUDIO
VIDEO R R
L
IN OUT
IN OUT
VIDEO R AUDIO L
S-VIDEO
CH3
CH4
IN FROM ANT
SATELLITE IN
OUT TO TV
Back of VCR
Back of Satellite Receiver
From
Satellite
Dish
RF Coaxial Cable
Audio/Video Cables
(supplied)
From
Cable, Cable Box
or Antenna
Back of TV
Cable/
Antenna
OR
VHF
UHF
RF Coaxial Cable
(supplied)
75 to 75/300 Ohm
Separator
IN
FROM
ANTENNA
OUT
TO
TELEVISION
MONO
L
Transmitting
Windows
Remote Sensor
Satellite Receiver