RCA VISYS H5450 - Manual (Page 26)

2. Lift the Cordless Handset from the charging cradle and press the Talk but-
ton to answer. Press the Speaker button for speakerphone operation. Press the
soft button to ignore the call.
NOTE: The soft button applies only to the current call.
3. To switch between handset and speakerphone: press the Speaker button to switch
to speakerphone; press the Talk button to switch to handset.
. To end the call, press the End button.
Ending a Call
To end a receiver call, a headset call or a speakerphone call, press the End button or
place the Cordless Handset in charging cradle.
Switching Between Audio Modes
During a call, you can switch among the following audio modes: receiver call, speak-
erphone call and headset call.
1. To switch to receiver call from headset call, unplug the headset.
2. To switch to headset call from receiver call, plug in the headset.
3. To switch to receiver or headset call from speakerphone call, press
Talk button.
4. To switch to speakerphone call, press Speaker button.
Putting Call(s) on Hold
The hold function allows the user to temporarily suspend a call up to 30 minutes.
This function is also used when setting up a conference call (Please refer to Three-
Way Conference Calls for details).
When a call is on hold, the extension that put the call on hold will remind the user
with three short beeps every 30 seconds. And the caller will hear pre-recorded hold
message every 15 seconds (Please refer to Hold Message for details).
Using Your RCA 25450 Phone System