Program change assign, P. 48) – Roland PCR-500 User Manual
Page 48
48
Settings (Edit mode)
Here’s how to assign a program change message to a controller.
Basic editing (->
fig.H-Edit.eps
1
Press the [EDIT] button so it’s lit.
fig.D-Edit.eps
The display will indicate “EDIT.”
fig.D-r1.eps
2
Slightly move the controller to which you want to assign a program
change message.
If the controller is a button, press it.
The display will indicate the number of the controller you selected.
3
Check the indication in the display, then press the [ENTER] button.
fig.D-PC.eps
4
Turn the VALUE knob to make “PC” appear.
5
Press the [ENTER] button.
fig.D-PCEdit0.eps
6
Turn the VALUE knob or press controller [A1 (0)] to select the basic
editing “PC0” indication.
fig.D-ChannelSelect.eps
7
Press the [ENTER] button.
The display will indicate “CH- -.”
* The - - portion shows the currently specified value.
8
Enter the channel. Use the VALUE knob or controller [A1 (0)]–[B2 (9)] to specify
the desired channel.
Program change assign
Edit
Controller
Display
MIDI transmit
channel
Bank MSB
Bank LSB
Value range
Port
Basic editing
[A1 (0)]
1–16
—
—
0–127
(00–7FH)
PORT 1
(fixed)
Advanced editing 1
[A2 (1)]
1–16
—
—
You can specify an
upper and lower limit
PORT 1
(fixed)
Advanced editing 2
[A3 (2)]
1–16
0–127
(00–7FH)
0–127
(00–7FH)
0–127
(00–7FH)
PORT 1,
PORT 2,
PORT 1+2
Advanced editing 3
[A4 (3)]
Current channel
—
—
PC DEC
PORT 1
(fixed)
Advanced editing 4
[A5 (4)]
Current channel
—
—
PC INC
PORT 1
(fixed)
PCR-300_500_800_e.book 48 ページ ２００６年１２月１９日 火曜日 午後２時５９分