RCA HD50LPW167 - Manual (Page 27)

Connections & Setup
Chapter 1 25
4. If your VCR stopped playing the tape, the test was successful. Highlight Yes
and press OK.
If your VCR didn’t stop playing the tape, you can either choose No or Test
this code again.
If the G-LINK wand is out of place, position it correctly (go to page 19 for
an example). If you think your TV or remote might have been touched
during the test, make sure the VCR is on and playing a tape. Highlight Test
this code again.
If you don’t think the test was interrupted, highlight No. Make sure the
VCR is playing a tape and is on. Press OK (the TV Guide On Screen system
starts testing another set of codes).
Keep following the previous instructions until the TV fi nds the correct code
for the VCR.
Note: If the TV Guide On Screen system can’t locate the correct code for
the VCR, a list of troubleshooting instructions appear to help you before
you try again.
• Try VCR confi guration again: repeat VCR setup.
• Test alternate codes: tests selected brands and if this fails, the test
continues with all codes in the system.
• Skip this step: the TV Guide On Screen system won’t be able to
automatically schedule programs to record on your VCR.
Step 6: Confi rming Your Settings
Check to make sure all settings are complete and correct. If all settings are
complete, highlight Yes, end setup and press OK. If your cable box and/or VCR
code testing failed, you should see INCOMPLETE where the cable box and VCR
codes are listed. Once setup is complete, additional screens appear.
If any settings are incomplete or incorrect, highlight No, repeat setup process
and press OK. Follow the instructions on the screen.
Tips
Leave your cable box turned ON all the time in
order to receive listings and record shows.
Leave your VCR turned OFF to record programs.