RCA HD50LPW167 - Manual (Page 22)

Connections & Setup
20 Chapter 1
Tip
To access the initial setup menus, press MENU
and choose Assisted Setup.
Tip
When remote batteries are low, the device
button corresponding to the mode you’re
in fl ashes when you press a button. Also, a
message might appear on the TV screen and
disappear within a few seconds. Press CLEAR and
replace the batteries to remove the message.
ON-OFF
TV
DVD VCR
AUX AUDIO SAT
SKIP
PRESETS CC
SOUND
CLEAR
FORMAT INFO
MENU
FREEZE
i
learning
LIGHT
CAB /
CC CC
CC M M
TV
button
Arrow
buttons
OK button
MENU
button
Plug in the TV
Plug the fl at end of the cable into the power jack on the back of the TV. Then plug the other
end of the power cord into an appropriate wall outlet. Be sure to insert the plug completely. Do
not plug the TV into an outlet controlled by a light switch.
Note: When you fi rst plug your TV into an outlet, the Power indicator on the front
panel will light and blink for approximately 30 seconds and then go off during the
initialization of the TV. This happens only when the TV is unplugged and plugged back
in. The TV can only be turned on after the Power indicator goes off.
Put Batteries in the Remote
• Remove the battery compartment cover from the back of the remote by
pushing down on the tab and lifting the cover.
• Insert 2 fresh “AA” batteries. Make sure the polarities (+ and -) are aligned
correctly with the polarities inside the remote.
• Replace the cover.
Turn on the TV
Press TV on the remote, or press the Power button on the TV’s front panel.
Note: Pressing the TV button turns on the TV and puts the remote into
TV mode. “TV mode” means that the buttons on the remote control
operate the TV’s functions.
Use the Remote Control to Complete the
Assisted Setup
The technical term is “Navigation” – how you move through the on-screen
menus. The method is the same throughout the menu screens: highlight your
choice and select it.
To use the TV’s menus, fi rst press the TV button on the remote control to put
the remote in TV mode. When the Assisted Setup screen appears, use the arrow
buttons to highlight one of the items listed in the menu. Use the up or down
arrow button to move up or down. Use the right or left arrow button to move
right or left.
To select the item that you’ve highlighted, press OK.
Note: Highlighted means that the menu item stands out from
other menu items on the list (appears darker, brighter, or a
different color).