Radio Shack 43-3577 - Manual (Page 9)

9
Se
tu
p
For wall mounting:
1. Turn the base holder so the wire hook is facing
the bottom of the base.
2. Insert the tabs into the top notches on the
bottom of the base, then snap the bottom taps
into place.
To remove the base holder:
Press the tabs located on the legs of the holder
to loosen, then lift the holder up and away from
the telephone base.
3 Connect Phone Base
1. Plug one end of the supplied modular cord into the TEL LINE jack and
plug the other end into a telephone wall jack.
2. Plug the supplied AC adapter’s barrel plug into the DC IN 9V jack and plug
the other end into a standard household outlet. Make sure the outlet is not
controlled by a wall switch.
3. Route the adapter and modular cords through the holder’s grooves.
n
Note: If you use Digital Subscriber Line (DSL) high-speed Internet service
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack to prevent noise and Caller ID
problems caused by DSL interference. Please contact your DSL service provider
for more information about DSL filters.
Telephone
base adapter
Telephone
wall jack
DSL filter
(optional, not
included)
Telephone base