Radio Shack TAD-733 - Manual (Page 7)

7
PREPARATION
SELECTING A LOCATION
You can place the phone on a desk top
or table, or mount it on a standard wall
plate. Select a location that is:
• near an accessible AC outlet
• near a telephone line jack
• out of the way of normal activities
• away from electrical machinery,
electrical appliances, metal walls or
filing cabinets, wireless intercoms,
alarms, and room monitors
The base’s location affects the phone’s
range. If you have a choice of several lo-
cations, try each to see which provides
the best performance.
Cautions:
You must use a Class 2
power source that supplies
9V DC and delivers at least
800 mA. Its center tip must be set to
positive and its plug must fit the
TAD-733's
DC 9V jack. The supplied
adapter meets these specifications.
Using an adapter that does not meet
these specifications could damage
the TAD-733 or the adapter.
• Always connect the AC adapter to
the TAD-733 before you connect it
to AC power. When you finish, dis-
connect the adapter from AC power
before you disconnect it from the
TAD-733.
INSTALLING
THE
HANDSET’S
ANTENNA
Screw the antenna into
the hole at the top of the
handset.
INSTALLING THE PHONE
On a Desk Top
1. Remove the mounting bracket by
holding in both tabs and gently pull-
ing out the wide end of the bracket.
2. Plug one end of the supplied long
modular cord into the telephone jack
on the back of the base.
3. Plug the modular cord’s other end
into a modular phone line jack.
!
43-733.fm Page 7 Friday, September 17, 1999 8:57 AM