Radio Shack TAD-733 - Manual (Page 18)

18
2. Place the headset on your head with
the earpiece over either ear and ad-
just the microphone boom until it is
about even with your chin.
3. Hang the belt clip on your belt.
4. Use the handset to make or receive
calls.
Notes:
• Connecting a headset disconnects
the handset’s earpiece and micro-
phone.
• If you place the handset on the base
to recharge it while the headset is
connected, be sure the handset
seats properly.
REMOVING THE BELT
CLIP
The belt clip on the back of the handset
lets you hang the handset on the belt for
easy portability.
Insert a flat-blade screwdriver into either
side of the belt clip, then pull it off.
To replace the belt clip, insert either tab
of the belt clip into one slot of the hand-
set, then snap the other tab into the other
slot of the handset.
43-733.fm Page 18 Friday, September 17, 1999 8:57 AM