Radio Shack TAD-733 - Manual (Page 12)

12
You can still make or receive calls using
this phone, and telephones on the same
line still ring when there is an incoming
call. The IN USE indicator on the base
and the TALK indicator on the handset
flash until you answer the call.
To turn on the base and handset ring-
ers, set
RINGER to ON .
Number of Rings
Set the 4/7/TS switch on the back of the
base to 4 , 7 , or TS to select how long the
TAD waits before it answers a call (4
rings, 7 rings, or toll-saver).
Note: If you plan to check your messag-
es by long distance, set the number of
rings to toll-saver (see “Using Toll-Sav-
er” on Page 24).
Setting The Ringer’s Volume
To adjust the ringer’s volume when the
phone is not in use, press
VOLUME or
on the handset.
Checking/Setting the Ringer
Tone
You can set the TAD 733’s handset to
sound any of four ringer types. The
handset is preset to use ringer tone 1.
To change or hear the different tones,
press
FLASH then 1 , 2 , 3 , or 4 when the
phone is not in use and RINGER is set to
ON . (The tone you hear corresponds to
the last number button pressed.)
SETTING THE DAY AND
TIME
You must set the day of the week and
time so the TAD can record the correct
day and time of each message. You can
set the day and time with either the
handset or the base.
Note: The system does not retain the
day and time settings when AC power
failure exceeds 2 minutes.
With the Handset
1. Press REMOTE . The REMOTE indi-
cator lights.
REMOTE
Indicator
43-733.fm Page 12 Friday, September 17, 1999 8:57 AM