Radio Shack TAD-733 - Manual (Page 23)

23
Note: You can replay a deleted mes-
sage by repeatedly pressing
REPEAT on
the base or REPEAT ( 4 ) on the handset
before the TAD announces “End of mes-
sages.”
To delete all played messages from a
mailbox or the message center, press
DELETE then the mailbox or message
center button. The TAD beeps.
Note: You must play a message before
you can delete it.
CHANGING THE REMOTE
OPERATION SECURITY
CODE
To use your TAD from a remote tele-
phone, you must first enter a 2-digit re-
mote operation security code. The
security code for your TAD is preset to
50. You can use the preset code, or fol-
low these steps to change it.
1. Press REMOTE on the handset. The
REMOTE indicator lights.
2. Press CHANGE ( ) then CODE (7) .
The TAD announces “Enter new
code.” Enter a new two-digit remote
operation security code. The TAD
announces “New code is xx” and
beeps twice.
Note: If you do not begin entering
the new code within 20 seconds, the
TAD beeps and stops the process. If
this happens, start over at Step 1.
3. Press REMOTE . The REMOTE indi-
cator turns off.
To check the remote operation security
code, press
REMOTE then CODE. The
TAD announces “Code is xx” and beeps
twice.
43-733.fm Page 23 Friday, September 17, 1999 8:57 AM