Radio Shack TAD-733 - Manual (Page 11)

11
• If the battery pack is completely dis-
charged or the base loses power
while the handset is away from it,
place the handset on the base to re-
set the security access-protection
code. If it was the handset that lost
power, recharge the battery pack.
• The supplied battery pack should last
for about a year. When the battery
pack loses its ability to fully recharge,
order a replacement battery pack
from your local RadioShack store
(see “Replacing the Battery Pack” on
Page 28).
SETTING THE DIALING
MODE AND RINGERS
Dialing Mode
Set T/P (Tone/Pulse) on the back of the
base for the type of service you have. If
you are not sure which type you have,
after you charge the handset battery
pack, do this simple test.
1. Set T/P to T .
2. Press TALK on the handset and lis-
ten for the dial tone. The TALK indi-
cator lights.
3. Press any number other than 0 .
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access
code either.
If the dial tone stops, you have
touch-tone service. Leave
T/P set to
T .
If the dial tone continues, you have
pulse service. Set
T/P to P .
4. Press TALK on the handset or place
the handset on the base to hang up.
Ringers
To turn off the ringers on the base, set
RINGER on the back of the base to OFF .
To turn off the ringer on the handset, set
RINGER on the left side of the handset to
OFF .
TALK
Indicator
43-733.fm Page 11 Friday, September 17, 1999 8:57 AM