Roland WORKSTATION GW-8 - Manual (Page 44)

44
Other Added Functions
(Owner’s Manual p. 39)
A new “Chord Zone” parameter has been added to the
performance settings, allowing you to specify the key range
for chord detection.
1. Press [MENU].
2. Use [ ] [ ] to select “Perform Edit” then press [ENTER].
3. Use [ ] [ ] to select the PERFORM GENERAL screen,
and use [ ] [ ] to select “Chord Zone.”
4. Turn the VALUE dial to edit the value.
5. When you’re finished making system settings, press [EXIT].
The Chord Zone setting applies only to the keyboard of the
GW-8 itself. If NTA is turned on, chords will be detected using
the entire range of notes from an external MIDI device.
Chord Zone
Parameter Value Explanation
Chord
Zone
OFF
Chord detection will not be
performed.
LEFT
Chords played to the left of
the split point will be
detected.
RIGHT
Chords played to the right of
the split point will be
detected.
WHOLE
Chords will be detected in
the entire key range.
GW-8_Ver2.book 44 ページ ２００９年６月８日 月曜日 午前１１時５５分