Roland WORKSTATION GW-8 - Manual (Page 15)

15
Creating a New Style
3. In the STYLE EDIT COPY =SOURCE= screen, select
“DESTINATION” and press [ENTER].
The STYLE EDIT COPY =DESTINATION= screen will
appear.
4. Use [ ] [ ] [ ] [ ] to move the cursor to the
parameter you want to change, and use the VALUE dial to
make the desired setting.
5. Select “EXECUTE” and then press [ENTER].
If you select “EXECUTE” and press [ENTER] when the Copy
Mode or Copy Times value is “- - -,” the copy will be executed
with the following settings:
Into = 0001:01:000
Copy Mode = REPLACE
Copy Times = 1
It is not possible to restore the data to its original state after
executing this operation.
From
(MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the beginning
of the region to be
copied.
If you’ve selected ALL as
the SOURCE part setting,
this is shown as “- - -” and
cannot be changed.
To (MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the end of the
region to be copied.
If you’ve selected ALL as
the SOURCE part setting,
this is shown as “- - -” and
cannot be changed.
Parameter Value Explanation
DESTINATION settings
PART
ADrum,
ABass,
Acc1–6
Selects the copy-
destination Style part.
If you select “ALL” in the
SOURCE settings, this
setting will be fixed at
“ALL” and cannot be
changed.
If you change the copy-
source Style, this will
change in tandem.
CHORD Maj, min, 7th
Selects the chord. If you
change the copy-source
Style, this will change in
tandem.
If you select “ALL” in the
SOURCE settings, this
setting will be fixed at
“ALL” and cannot be
changed.
Parameter Value Explanation
DIVISION
INT1–4,
MAIN1–4,
FILL1–4,
END1–4
Selects the division.
If the SOURCE setting
DIVISION is set to
“xxxALL,” this setting will
be fixed at “xxxALL” and
cannot be changed.
If you change the copy-
source Style, this will
change in tandem.
Into (MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the beginning of
the region at which the
copied data is to be
pasted.
If you’ve selected ALL as
the SOURCE part or
SOURCE chord setting,
this is shown as “- - -” and
cannot be changed.
Copy Mode REPLACE, MIX
Specifies the copy
method.
If you’ve selected ALL as
the SOURCE part or
SOURCE chord setting,
this is shown as “- - -” and
cannot be changed.
Copy Times 1–99
Specifies the number of
times to copy the data.
If you’ve selected ALL as
the SOURCE part or
SOURCE chord setting,
this is shown as “- - -” and
cannot be changed.
Parameter Value Explanation
GW-8_Ver2.book 15 ページ ２００９年６月８日 月曜日 午前１１時５５分