RCA VR688HF - Manual (Page 14)

SETUP
Would you like to set
up the VCR to control
a cable box?
1 Yes
2 No
12
Setting Up the VCR
7. RCA digital satellite receiver and/or cable box setup. (continued)
Startup
CABLE BOX SETUP
Do you use your cable
box to receive ALL
channels?
1 Yes
2 No
CABLE BOX SETUP
On what channel does
the VCR receive signals
from the cable box
(usually 3, 4, or video)
--
Press 01-13 or INPUT
Press MENU to exit
CABLE BOX SETUP
The VCR will now
receive all signals
from the cable box
on channel 03
Press MENU to proceed
CABLE BOX SETUP
Enter the code for your
cable box from the
list in your User's
Manual.
--
Press MENU to exit
CABLE BOX SETUP
Please turn on the
cable box and tune
it to channel 2.
Press MENU to proceed
CABLE BOX SETUP
Did the cable box
tune to channel 9?
1 YES, setup is complete
2 NO, try again
Cable Box Setup
E. Setup the VCR to control a cable box:
Press 1 if you would like to setup the VCR to
control a cable box.
Press 2 if you do not want to setup the VCR to
control a cable box.
F. Cable box not used for all channels:
Press 2. You are finished with CABLE BOX
SETUP
. Skip to Step 8.
Cable box used for all channels:
Press 1 to continue.
Press two numbers on the remote to enter the
channel that your VCR receives signals from
your cable box. Press 0 before a single-digit
number. Valid numbers are 01 – 13.
If you connected your cable box to the VCR
using the boxÕs AUDIO/VIDEO OUT jacks, press
INPUT
to select VIDEO1 or VIDEO2.
Press CLEAR on the remote to correct an entry.
G. Press MENU•PROG to proceed.
The VCR will now receive all signals from the
cable box on channel – –
message appears.
H. Press MENU•PROG to proceed.
I. Manually Controlled Cable Box: You are
finished with cable box setup. Press
MENU•PROG
to exit. Proceed to Step 8.
Remote Controlled Cable Box: Enter your
cable box code from the chart on the next page
and follow the on-screen directions. The VCR
changes the cable box from channel 02 to
channel 09 when you enter the correct code for
your cable box.
If none of the codes work, try repositioning the
cable box and entering the codes again. If the
codes still do not work, this VCR cannot
control your cable box during VCR plus+ or
timer recordings. Press MENU•PROG to exit
the CABLE BOX SETUP. Proceed to Step 8.