Roland GA-212 - Manual (Page 8)

Panel Descriptions
6
Rear Panel (Connecting Equipment)
AC IN Jack
Connect the provided
power cord to this jack.
FOOT CONTROL/LINK IN, LINK OUT Jacks
FOOT CONTROL jack
This is for connecting a stereo cable to the GA FOOT
CONTROL jack of the foot controller.
* Always use a stereo cable.
To a power supply
[AUTO OFF] Switch
CAUTION
This switch controls the AUTO OFF function
that automatically switches off the unit after
the fixed time has elapsed.
When the AUTO OFF function is switched
on, the unit will automatically be turned off
approximately 4 hours after last use.
If you don’t want the unit to turn off
automatically, set the switch to OFF.
To turn the unit back on after the AUTO OFF
function has turned the unit off, turn the [ON]
switch back on (p. 5), or set the [AUTO OFF]
switch to OFF.
MAIN IN Jacks
To output the sound created with a multi-effects unit or
other devices, connect to the MAIN IN jacks.
GA-212 plays the A jack input sound from the left speaker,
and the B jack input sound from the right speaker. When
only the A jack is used, the same sound is played from the
right and left speakers. When only the B jack is used, sound
is only played from the right speaker.
GA-112 mixes the A and B jack input sounds and plays from
the speaker.
CAUTION
* If the AUTO OFF function is switched on, and only the signals
from the MAIN IN jack are input with no other operation, after
approximately 4 hours the unit is automatically turned off.
LINE OUT Jack
This is for connecting a PA
system, recorder or other
external equipment.
LINK IN jack/LINK OUT
jack
Use these jacks to make link
connections for GAs.
For details, see p. 9
THRU/TUNER OUT Jack
A guitar’s direct sound from the INPUT jack is output.
Use this to make unit link connections.
For details, see
p. 9
A tuner can also be connected.
*1