Radio Shack HTX-242 - Manual (Page 40)

40
TROUBLESHOOTING
Error Codes
Your HTX-242 has the following three built-in error codes.
tF Err —appears if you try to transmit outside the allowed range
(see “Extending the Transmit Frequency Range” on Page 16).
PLL Err —appears if the HTX-242’s PLL (phase-locked loop) sec-
tion malfunctions. If turning the HTX-242 off then back on does
not correct this error, take it to your local Radio Shack store to
arrange for service.
EEP Err —appears if the HTX-242’s EEPROM checksum fails. Try
resetting the HTX-242 (see “Resetting the HTX-242” on Page 16). If
this does not clear the error, take it to your local Radio Shack store
to arrange for service.
Common Problems and Solutions
If your HTX-242 does not seem to be operating properly, check this
section for a possible solution.
Problem Possible Solutions
Signal strength meter
shows a signal and
BUSY appears, but no
sound from speaker.
Be sure DTMF is not on the display. If it is,
press DTMF to turn off DTMF page.
Be sure T-SQL is not on the display. If it
is, press T-SQL until neither T nor T-SQL
appears.
Be sure VOLUME and SQUELCH are prop-
erly adjusted.
Be sure nothing is plugged into the EXT.
SP jack.
No controls operate. Be sure LOCK is not on the display. If it is,
press F then LOCK to unlock the controls.
Be sure LOCK on the microphone is set to
its leftmost position.
Other party cannot
hear your transmis-
sion. Be sure the duplex offset is set correctly.
Set the output power to high by pressing
LOW so HIGH appears on the display.
The display does not
light when you press
POWER .
Check the power connections.
Check the fuse (see “Replacing the Fuse”
on Page 41).