Radio Shack HTX-242 - Manual (Page 31)

31
Scanning Memory Channels
To set the HTX-242 to scan memory channels, press and release
MR . Then press and hold MR for at least 1 second. . flashes, and
the HTX-242 scans memories that have the scan option turned on
(see “Enabling/Disabling Scanning for Memory Channels” on this
page). The HTX-242 stops when it encounters a transmission. It
resumes scanning according to the saved scan settings (see “Set-
ting the Scan Options” on Page 20). To resume scanning immedi-
ately, press
MHz .
Clearing a Memory Channel
You can clear any memory channel except Memory Channel 1 and
the calling-frequency memory.
1. Tune to the memory channel you want to clear.
2. Hold F for at least 1 second. FUNC flashes.
3. Press MR . All settings are cleared from the memory channel.
Enabling/Disabling Scanning for Memory Channels
You can disable (lock out) individual memory channels, so the
HTX-242 does not stop on them when you scan memory channels.
1. Tune to the memory channel you want to enable or disable
for scanning.
2. Press F , then press MR .
3. Repeatedly press
▲
until the HTX-242 displays Sn and the
scan setting.
4. To enable scanning for the current channel, rotate TUNE , or
press UP or DOWN on the microphone, to select on .
To disable scanning for the current channel, rotate TUNE , or
press UP or DOWN on the microphone, to select oFF .
5. Press MR or PTT to save the setting.
Note: Scanning stops if you press MR or PTT.
!