Radio Shack HTX-242 - Manual (Page 35)

35
Using DTMF Auto Send
If you turn on the DTMF auto-send feature, the HTX-242 automat-
ically sends the sequence stored in the currently-selected DTMF
memory every time you press PTT.
Follow these steps to turn on auto send.
1. Press VFO .
2. Hold F for at least 1 second. FUNC flashes.
3. Press MR .
4. Repeatedly press
▲
to select the dA option. Then rotate
TUNE , or press UP or DOWN on the microphone, to set the
option to on .
5. Press MR or PTT to save the setting.
6. Press DTMF so DTMF is on the display.
To temporarily turn off auto send, press DTMF so DTMF is not on
the display. To turn off auto send, set the option to oFF in Step 4.
Notes:
• This feature works with the DTMF page feature. If you stored a
sequence in DTMF Memory 0, the HTX-242 does not pass trans-
missions to the speaker until it receives that sequence. After the
transmission, DTMF squelch is still turned on.
• If there is no sequence stored in DTMF Memory 0, the HTX-242
still transmits the currently selected DTMF memory sequence
each time you press PTT, but passes all transmissions to the
speaker.
!