Radio Shack PRO-92 - Manual (Page 31)

31 Operation
Notes:
• If you made a mistake in Step 3, Invalid
Freq briefly appears and the scanner beeps
when you press ENTER . Start again from Step 3.
• Your scanner automatically rounds the entered
frequency to the nearest valid frequency. For
example, if you enter a frequency of 151.473,
your scanner accepts it as 151.470.
• Press FUNC then DELAY/1 to turn the delay func-
tion on or off. To have the scanner pause for 2
seconds on this channel after a transmission
before proceeding to the next active transmis-
sion, see “Using the Delay Function” on Page 40.
The scanner stores this setting in the channel.
• If you are storing frequencies for an EDACS sys-
tem, you must store them in logical channel num-
ber order, with the first frequency in channel 1 for
the current bank.
5. If necessary, press MODE to change the receiving
mode. If you select P/L or DPL , enter the PL or
DPL code by pressing STEP (to move up through
the codes) or FUNC then STEP (to move down
through the codes).
6. If desired, program a text tag for the channel (see
“Assigning a Text Tag to a Channel”).
7. The next channel in sequence is ready for program-
ming. Press PGM and then repeat Steps 3 through
5.
STORING TEXT TAGS
You can customize your scanner by storing text tags (up
to 12 characters) for easy identification of channel trans-
missions, trunk IDs, or banks.
Assigning a Text Tag to a Channel
1. Press MANUAL , enter the channel number where
you want to enter the text, then press MANUAL
again. M and the channel number appear at the
upper left corner of the display (for example: M100 ).
20-522b.fm Page 31 Thursday, September 7, 2000 9:41 AM