2 selecting the input source, 3 setting the computer display properties, Selecting the input source – Runco PLASMAWALL SP-60DHD / SP-60DHDXA User Manual
Page 42: Setting the computer display properties, Iminar, Pre l iminar y
32
PlasmaWall SP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
4.2
Selecting the Input
Source
By default, the PlasmaWall is configured to display the signal received on its RGBHV
(ANALOG RGB IN) input. To use the DVI-D (DIGITAL RGB) input instead:
1. Press MENU and enter the Service Menu passcode.
2.
Select Service from the Main Menu.
3.
Select Display Device from the Service Menu.
4.
Press
to select DVI/HDMI, then press ENTER.
4.3
Setting the Computer
Display Properties
To maximize image quality when using the PlasmaWall with a personal computer, you
may need to adjust the display properties of your computer’s video card. To do this on a
Microsoft® Windows®-based PC:
1. Choose Settings from the Windows Start
Menu and click on “Control Panel.”
2. Double click on the Display icon.
3. Click the Settings tab on the display dialog
box.
4. Adjust the resolution to 1024x768 pixels.
You must enter a passcode to access the Service menu.
Note