Rs-232 controller connection, Figure 3-9 . rs-232 control system connection, Figure 3-10 . connecting 12-volt trigger outputs – Runco PLASMAWALL SP-60DHD / SP-60DHDXA User Manual
Page 39: 9. rs-232 control system connection, 10. connecting 12-volt trigger outputs, Pre l iminar y
PlasmaWall SP Series Owner’s Operating Manual
29
PRE
L
IMINAR
Y
RS-232 Controller
Connection
Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 Control port on the DHD Controller; see Figure 3-9.
For more information about using this connection, refer to Serial Communications on
page 53.
Figure 3-9. RS-232 Control System Connection
Connecting 12-Volt
Trigger Outputs to
External Equipment
If your home theater contains equipment that responds to 12-Volt triggers, connect it to
the 12-Volt trigger outputs as shown in Figure 3-10.
Figure 3-10. Connecting 12-Volt Trigger Outputs
Pb
Pr
Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 Out
Component Video
1
2
3
4
5
7
8
9
6
to Automation/
Control System
or PC
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
Pb
Pr
Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 Out
Component Video
to 12-Volt
trigger-activated
equipment
3.5-mm
mini plug
Tip = +12V
Sleeve = Ground