Roland HandSonic 10 - Manual (Page 22)

20
Getting Familiar
1. Press the [COACH] button and use the [ ] or [ ] cursors until
you see in the display.
2. Press the [ ] button and watch the display.
You will see the tempo indicator increase 1 BPM every two beats.
3. Press the [ ] button again to stop.
4. Press the [ ] and you see:
If you set the RATE to 1, the tempo will increase 1 BPM every measure, and if you set the RATE to 3, the
tempo will increase 1 BPM on every beat.
While the metronome is playing, you’ll also notice in the left side of the display, 90
→ 200.
This is showing you the MINIMUM TEMPO and MAXIMUM TEMPO. This means that the metronome will
start playing at 90 BPM, increase to 200 BPM, and then go back down to 90 BPM.
You can adjust this by pressing the [
] once, where you will see in the display. Use the [+]/
[-] buttons or the Control knob to set your desired tempo. Push the [ ] once more and you see
Tempo>.
Also, while the metronome is playing, you can set the Max Tempo by pushing the [-], and you will see max tempo> in the display. If you push the [+] you will see and it will be reset to 200
BPM.
1. Press the [COACH] button and use the [ ] cursor until you see
.
Here, you can tap any pad, or external trigger to set the Tempo.
This is useful as a training exercise, because as you tap the pads, you can see the tempo indicated in the
display. Very good for tempo training.
Auto Up/Down
Tap Tempo
You can adjust the tempo(min tempo) when any of the coach mode functions appears in the display, or while
the metronome is running with the Control knob or using the [+]/[-] buttons. (except for Auto Up/Down)
HPD-10_e1.book 20 ページ ２００６年４月７日 金曜日 午後２時１４分