RCA RCU600M - Manual (Page 6)

Program for VCR—Direct Entry Method
1. Manually turn on the VCR.
2. Locate the enclosed VCR Code List.
Find your brand in the VCR Codes.
Note : If your brand isn’t listed, use one
of the Code Search methods to program
this remote control. (See section on
Code Search on page 10).
3. Press and hold the CODE SEARCH key
until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the VCR key. The
indicator light blinks and then remains lit.
5. Use the number keys on the remote to
enter the first code listed for your brand.
After you enter a valid three-digit code,
the indicator light turns off.
Note : If you enter an invalid code, the
LED flashes rapidly for two seconds.
Start over at step 3.
6. Aim the remote at your VCR. Press the
ON•OFF key. If your VCR turns off, you
have found the correct code.
7. Enter the code in the box provided on
this page for future reference.
8. If your VCR does not turn off, repeat
steps 3-6 above, entering the next code
for your brand.
If none of the codes work or your brand
is not listed, use one of the Code Search
methods to program this remote.
(See Code Search section on page 10).
In order for the six-component universal remote to control your VCR, you
must program it with the code that matches your VCR. To program your
remote to control your VCR, follow these steps:
(BLINK)
VCR CODE
(OFF)
1. Manually turn on the DVD/CD system.
2. Locate the enclosed DVD or CD Code
List. Find your brand in the DVD or
CD Codes.
Note : If your brand isn’t listed, use one
of the Code Search methods to program
this remote control. (See section on
Code Search on page 10).
3. Press and hold the CODE SEARCH key
until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the DVD key. The
indicator light blinks and then remains lit.
5. Use the number keys on the remote to
enter the first code listed for your brand.
After you enter a valid three-digit code,
the indicator light turns off.
Note : If you enter an invalid code, the
LED flashes rapidly for two seconds.
Start over at step 3.
In order for the six-component universal remote to control your DVD or CD
systems, you must program it with the code that matches your component.
To program your remote to control your DVD/CD system, follow these steps:
(BLINK)
Program for DVD/CD Systems—
Direct Entry Method
6
CODE
SEARCH
INDICATOR
LIGHT
CODE
SEARCH
INDICATOR
LIGHT
(OFF)
ON•OFF
VCR
DVD
RCU600M_IB_resized.qxd 3/24/04 4:10 AM Page 6