Manual code search, Auto code search, Code search methods – RCA RCU600M User Manual

Page 10

Code Search Methods

Manual Code Search

1. Manually turn on the component you

want the remote to operate.

2. Press and hold the CODE SEARCH key

until the indicator light illuminates.
Then release the CODE SEARCH key.

3. Press and release the component key

that corresponds to the component you
want the remote to operate (TV, VCR,
DVD, DBS•SAT, CABLE, AUDIO

). The

indicator light blinks once and then
remains lit.

4. Aim the remote at the component. Press

the ON•OFF key continuously until the
component turns off.

Important

: Because there are so many

codes, you may have to press the
ON•OFF

key many times—possibly up

to 200 times.

5. When the component turns off, press

the ENTER key to store the code.

6. Use the Code Retrieval section on the

next page to identify the code for your
component for future reference.

Auto Code Search

1. Turn on the component you want the

remote to operate.

2. Press and hold the CODE SEARCH key

until the indicator light illuminates.
Then release the CODE SEARCH key.

3. Press and release the component key that

corresponds to the component you want
the remote to operate (TV, VCR, DVD,
DBS·SAT, CABLE, AUDIO

). The indicator

light blinks once and remains lit.

4. Aim the remote at the component and

press the ON•OFF key once. The remote
automatically sends every code for
the specified component one at a time,
with the three-second delay between
each code. Keep the remote aimed at the
component throughout this process.

5. As soon as the component turns off, you

must press the ENTER key immediately
so the remote stores the correct
code. If you do not press the ENTER
key within three seconds, the remote
sends the next code in the list, and you
will have to start over from step 2.

6. Use Code Retrieval section on the next

page to identify the code for your
component for future reference.

If your component’s brand is not listed in the Code List or you have tried all
the codes for your brand and the remote does not operate your component,
use one of the Code Search methods below—Manual Code Search or Auto
Code Search. Both Code Search methods search all of the codes since
your component’s code may be listed under another brand in the Code List.

Note

: The Code Search method may take a long time because the remote

searches all of the codes in its memory for the code that operates your
component. Therefore, if your brand is listed in the Code List, use the
Direct Entry method described on pages 5-9.

(OFF)

(BLINK)

CODE

SEARCH

INDICATOR

LIGHT