RCA RCU600M - Manual (Page 5)

Program for TV—Direct Entry Method
Secondary Key Descriptions For AUDIO Operations
In order for the six-component universal remote to control your TV, you must
program it with the TV code that matches your TV. These instructions explain
the preferred method of programming the remote—the Direct Entry
method. To program your remote to control your TV, follow these steps:
ON•OFF
TV CODE
CODE
SEARCH
INDICATOR
LIGHT
(BLINK) TV
5
(OFF)
1. Manually turn on the TV.
2. Locate the enclosed TV Code List. Find
your brand of TV.
Note : If your brand is not listed, use one
of the Code Search methods to program
this remote control. (See section on
Code Search.)
3. Press and hold the CODE SEARCH key
until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the TV key. The indicator
light blinks and then remains lit.
5. Use the number keys to enter the first
code listed for your brand. After you
enter a valid three-digit code, the
indicator light turns off.
Note : If you enter an invalid code, the
LED flashes rapidly for two seconds.
Start over at step 3.
6. Aim the remote at your TV and press
the ON•OFF key. If your TV turns off,
you have found the correct code.
7. Enter the code in the box provided on
this page for future reference.
8. If your TV doesn’t turn off, repeat steps
3-6 above, entering the next code for
your brand.
If none of the codes work or your brand
is not listed, use one of the Code Search
methods to program this remote.
(See Code Search section on page 10.)
Certain keys on the six-component universal remote have dual functions. Secondary
key functions are printed in blue on the remote and are used for AUDIO operations.
Not all functions work for all brands. Experiment with your AUDIO system to
determine which functions work with your components.
See the enclosed AUDIO Code List to operate your brand of equipment.
Press the AUDIO key to enable the Audio Mode.
AM•FM: allows you to select the AM•FM band on your AUDIO receiver.
CD , TAPE, TUNER, TV, VIDEO 1, VIDEO 2: For some AUDIO systems, these
keys will select the corresponding component input.
DELAY- , ON, DELAY+: increases or decreases the delay between the surround and
main speakers when the receiver is in the Surround Sound Mode.
DSP ON•OFF: enables the receiver’s Digital Signal Processing Mode.
DSP MODE: When the DSP mode is enabled, pressing this key allows the
user to cycle through the various DSP Modes.
FRONT , CENTER, REAR, TEST: adjusts the levels of the front, center, and
rear speakers used with LEVEL+/ LEVEL-. The test tone must be enabled
first by pressing the TEST key.
FUNCTION: selects the different AUDIO input components. The number keys
also select the function labeled below the keys when in Audio Mode.
LEVEL+/LEVEL-: sets the level of the speakers during Test Tone Mode.
PRESET: cycles through preset channels while the Tuner input on your
AUDIO system is active.
RCU600M_IB_resized.qxd 3/24/04 4:10 AM Page 5