Nokia 2255 - Manual (Page 35)

Copyright © 2005 Nokia. All rights reserved.
S e t t i n g s
27
Divert if out of reach —Divert
incoming calls to the number you
specify if your phone is out of
network.
Cancel all diverts —Cancel any call
diverting options you have set.
This option does not require that
you perform step 2.
2. Select Activate > OK to enter the
number to which calls are diverted
or Cancel .
Call waiting
If your wireless provider supports this
feature, call waiting notifies you of an
incoming call even while you are in a
call. You can then accept, decline,
or ignore the incoming call.
1. In standby mode, select Menu >
Settings > Call settings >
Call waiting > Activate , Cancel ,
or Cancel for next call and enter a
number at the prompt.
2. During a call, select Answer ,
or press the call key to answer the
waiting call, and put the first call
on hold.
3. Press the end key to end the active
call and the held call.
Send my caller ID
If your wireless service provider or
network operator supports this feature,
you can prevent your number from
appearing on the receiving party
caller ID.
In standby mode, select Menu >
Settings > Call settings > Send my
caller ID with next call and the number
you are calling at the prompt, or select
Off to turn this feature off. This feature
allows you to display your number on
the receiving party’s caller ID for the
next call only.
Own number selection
To view your own phone number or,
if your phone can use more than one
number, to select the active number,
in standby mode, select Menu >
Settings > Network settings >
My number selection .
Note: This is a network
operator dependent service.
■ My menu settings
When you press the right selection key
in standby mode, the device displays a
list of shortcuts to various functions.
To define the functions to be shown in
this list, select Menu > Settings >
R. navigation key settings and one of
the following:
Select options —Scroll to each function
that you want as a shortcut, and select
Mark . The functions are listed in the
shortcut list in the order you select
them. When you have selected all
desired functions, select Back > Yes .
To exit the menu without saving,
select Back twice.