Nokia 2255 - Manual (Page 32)

Copyright © 2005 Nokia. All rights reserved.
S e t t i n g s
24
Make calls
After you have saved your calling card
information in your phone, make a call
with your calling card.
1. In standby mode, select Menu >
Settings > Call settings > Calling
card .
2. Enter your security code, and select
OK . See “ Security settings ”, p. 25 .
3. Scroll to the calling card of your
choice, select Options > Select >
OK .
4. Press the end key to return to
standby mode and enter the phone
number, including any prefix (such
as 0 or 1) that your calling card
may require when you make a
calling card call. See your calling
card for instructions.
5. Press and hold the call key for a few
seconds until Card call is displayed.
6. When you hear the tone or system
message, select OK .
■ Phone settings
Select Menu > Settings > Phone
settings and one of the following:
Language —Select a language for the
display texts.
Automatic keyguard —Select On when
Set delay: appears, enter the time,
and select OK . You can set the time
from 10 seconds to 60 minutes.
To deactivate the automatic keyguard,
select Off . It may be possible to dial
the emergency number programmed
into your device when the keyguard
is on.
DTMF tones —Select the tones that
sound when you press the keys on your
keypad: DTMF tone length or Manual
DTMF tones .
Start-up tone —Switch the tone On or
Off that sounds when the phone is
switched on.
Welcome note —Enter a message that
will be shown briefly on the display
when the device is switched on.
Banner —Set the device to display the
operator logo ( Default ) or your own
message ( Personalise ) when the device
is in the idle state. This is a network
operator dependent feature.
Confirm UIM service actions —Set the
UIM card services.