Nortel Networks Media Dependent Adapters 302403-G - Manual (Page 31)

29
Figure 11 Installing a GBIC
3 Press on the front of the GBIC until it snaps into place.
4 Remove the rubber plug to connect cables.
Removing an Installed GBIC from an MDA
For a description of the GBIC MDA, see “GBIC MDA” on
page 22 .
To remove an installed GBIC:
• If the GBIC has spring tabs ( Figure 9 on page 23 ), press in
on the tabs on each side of the GBIC as you pull the GBIC
out of the MDA’s Host port (
Figure 12 ).
Do one of the following: