Nautique 230 - Manual (Page 218)

8-16
Section 8
Transmission
Allow the transmission to cool and check with the boat level.
1. Remove the drain/fill plug from the transmission.
2. Verify the fluid level; the fluid level should be at the bottom of
the threaded hole. If low, add the specified fluid through the
threaded hole to the proper level.
NOTICE
The transmission fluid is a very high viscosity, to make adding
fluid easier, remove both fill plugs.
3 Replace the drain/fill plug and tighten securely.
PL EASURE CRA FT EN GINE GRO UP POWER PLU S
RATIO 1.48
MADE IN USA
Oil Fill/Drain
Plug
Oil Fill/Drain
Plug
Raw Water
Drain Plug
CORC210
Burn hazard from hot transmission fluid
can cause serious injury. Do not remove the
transmission drain/fill plug while the engine is running
or while the transmission is hot.
!
V-Drive Sec 8_2010.qxp:Naut Air Sec 8.qxd 7/22/09 1:47 PM Page 8-16