Nautique 230 User Manual
Page 162
4-86
Section 4
Ballast Tanks
The tanks increase the wake for wake boarding, making your
Nautique the most versatile watersports tow package in the world.
Ballast Tank Control Switches
Press the button for the ballast tank you choose to fill or drain.
To fill:
Press and release quickly; the LED will illuminate and the
pump will begin to fill the tank. Press the button again to stop the
pump. Use the tank gauge to measure the level of water in the tank.
If you continue to fill the tank beyond its capacity, the excess water
will expel from the tank vent. The pump will continue to operate
for approximately 10 minutes if the pump is left in the fill mode,
then shut off.
To drain:
Press and hold the button until the LED begins to flash
and the pump will begin to drain the tank. Press the button again
to stop the pump.
The pump will stop pumping when the tank sensor senses the “No
Water Level” in the tank. The LED will continue to flash for
approximately 10 minutes unless the button is pressed again.
V-Drive Sec 4_2010.qxp:Naut Air Sec 4.qxd 7/22/09 1:45 PM Page 86