Nautique 230 - Manual (Page 204)

8-2
4. When servicing the ignition switch or any wiring, always
disconnect the battery cables from the battery.
5. Check for water circulation when the engine is running.
Exhaust should contain steady flow of water. In closed cooling
systems, make sure the coolant in the cooling system is at the
proper level.
Engine Intake Water Strainer
Visually inspect the engine intake water strainer for debris before
each use. To clean the strainer, close the engine intake water valve
and unscrew the strainer bowl (A). DO NOT lose the rubber O-ring
(B)
that seals the bowl to the cap. Carefully remove the screen (C).
Clean debris from the bowl and screen and rinse parts in fresh
water. Insert the screen, place the O-ring in the groove of the bowl
and screw the bowl on hand tight. Be sure to open the water valve
before starting the engine.
CORC0232
RAW WATER
STRAINER
CORC078
A
B
C
Section 8
V-Drive Sec 8_2010.qxp:Naut Air Sec 8.qxd 7/22/09 1:47 PM Page 8-2