Nortel Networks 4500 Series - Manual (Page 24)

24 Small form factor pluggable transceivers
Model and connector Product number Description
100BASE-FX (LC)
AA1419074-E6 1310 nanometers (nm), up to 2 km
Supported by the 4526FX, 4526T,
4526T-PWR, 4550T, 4550T-PWR
and 4524GT
T1 (RJ-48C) AA1419075-E6
1.544 Mbit/s Fast Ethernet to T1
remote bridge. Supported by the
4526FX, 4526T, 4526T-PWR,
4550T, 4550T-PWR and 4524GT
For specifications for these SFPs, see “SFP specifications” (page 35) .
Job aid: SFP models with DDI support
Any Digital Diagnostic Indicating (DDI) SFP can be used in any Ethernet
Routing Switch 4500 that supports SFPs beginning with Release 5.2. The
optical functions of the SFP are supported. Access to the DDI information
will be provided in a future release.
The following table lists and describes the Nortel SFP models with DDI
capability.
Table 3
SFP models with DDI capability
Model Product number Description
1000BASE-T (RJ-45) AA1419043-E6 CAT5 UTP, up to 100 m. Note that
because the 1000BASE-T device is
all electrical, there is no need for DDI
support.
1000BASE-SX AA1419048-E6 850 nm, up to 275 or 550 m
1000BASE-LX AA1419049-E6 1310 nm, up to 10 km
1000BASE-BX (LC type) AA1419069-E6,
AA1419070-E6 Bidirectional 1310 nm and 1490 nm, up
to 10 km
For specifications for these SFPs, see “SFP specifications” (page 35) .
Installing an SFP
Install an SFP to provide an interface between the switch and the network
cable.
Installing an SFP takes about three minutes.
For translations of the following messages, see “Product safety warnings
and information” (page 16) .
Nortel Ethernet Routing Switch 4500 Series
Installation — SFPs and XFPs
NN47205-301 02.01
20 October 2008
Copyright © 2007-2008 Nortel Networks
.