NETGEAR ProSafe SSL312 - Manual (Page 93)

NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
Additional System Configuration 7-5
v1.1, November 2006
If your corporate network contains other subnets whose resources will be made available through
remote SSL connections, you must configure static routes to those subnets. To configure a static
route:
1. In the Add Static Routes section, enter the destination network address of the static route in the
Destination Network field. The destination network address is an IP address in the remote
network subnet.
2. In the Subnet Mask field, enter the subnet mask of the remote network segment.
Figure 7-3
Note: The destination network address may be a valid IP address or it may be a
subnet address that ends in .0, such as 192.168.0.0.