Nikon Coolpix 2500 - Manual (Page 57)

45
Connections
Before Connecting the Camera
Before connecting your camera to a computer, make sure that Nikon View 5
is installed.
Use a Reliable Power Source
When transferring data between the camera and the computer, be sure that
the battery is fully charged. If in doubt, recharge the battery before begin-
ning transfer or use the optional EH-60 AC adapter.
4 Turn the computer on
Turn the computer on and wait for the operating system to start up.
5 Connect the camera and computer
Connect the UC-E3 USB cable as shown below. Use the flat connector for
connection to the computer, and connect the other end of the cable to the
camera’s USB connector. Do not connect the camera via a USB hub or
keyboard.
6 Turn the camera on
Slide the mode selector to
or . If the UC-
E3 is connected, the monitor will remain off,
and all controls except the
( ) button
and power switch will be inactive.