Nortel Networks COOLPIX S5100 - Manual (Page 136)

124
Setup Menu
Basi
c Came
ra Setup
3
Press K.
The travel destination screen is displayed.
4
Press J or K to choose the travel destination
time zone.
If daylight saving time is in effect, press H to enable
daylight saving time function. W is displayed at the top
of the monitor and the camera clock is advanced one
hour. Press
I to disable the daylight saving time
function.
Press the k button to apply the travel destination time
zone.
While the travel destination time zone is selected, the Z
icon will be displayed in the monitor when the camera is
in shooting mode.
Time zone
1 5 / 1 1 / 2 0 1 0 1 5 : 3 0
Lo n d o n , C a s a b l a n c a
Home time zone
Travel destination
Exit
Back
1 0 : 3 0 – 0 5 : 0 0
E DT:
N e w Yo r k
To ro n t o
L i m a
Time zone
1 5 / 1 1 / 2 0 1 0 1 0 : 3 0
E DT: N e w Yo r k
To ro n t o, L i m a
Home time zone
Travel destination
Exit
B
Note on the Clock Battery
The camera clock is powered by the clock battery. The clock battery charges when the main battery
is inserted or an AC adapter is connected, and can provide several days of backup power after about
ten hours of charging.
C
w Home Time Zone
• To switch to the home time zone, choose w
Home time zone in step 2 and press the k button.
• To change the home time zone, choose w
Home time zone in step 2, and complete steps 3 and
4.
C
Daylight Saving Time
When daylight saving time starts or ends, turn the daylight saving time function on or off from the
time zone selection screen displayed in step 4.
D
Imprinting Date on Images
Enable date imprint from the
Date imprint option (A 128) in the setup menu after the date and
time have been set. When the
Date imprint option is enabled, images will be saved with shooting
date imprinted on them.