Console – boot loader – NetComm NP2624M User Manual
Page 57
NP2624M User Guide
57
YML827 Rev1
3. Console – Boot Loader
Each time the switch restarts, the user can get some basic information from console (use Hyper
terminal 57600 baud rate).
After switch tests are done, a 5-seconds countdown timer will prompt the user to press any key to
enter the “User Menu”.
There are five functions in the menu:
1. start kernel:
Back to switch system initiation and enter login.
2. kernel update from xmodem :
Use 1k X modem to update firmware.
3. kernel update from tftp:
Use TFTP to update firmware.
4. set ip address:
A shortcut to setup switch IP and gateway.
5. diagnose sdram:
A basic SDRAM diagnosis.