N-Tron 710FX2 - Manual (Page 167)

(Revised 2012-05-01 Page 167 of 170
Appendix A. XML Settings File Example
-- Overview of XML settings for N-TRON switches -- >
-- XML settings can be downloaded to a switch to configure the switch. XML settings cover a
subset of the settings available through a web browser. -- >
-- There are several top level configuration sections. Each section is optional.
--
>
<
SystemConfiguration version ="1" minSwVer ="3.4.2">
-- The minSwVer attribute is optional. If present, the XML settings are ignored if the
switch software version does not meet the minimum version requirement -- >
-- ______________________________________________________________________________________ -- >
-- The Switches block is optional. If present, the model name of the target switch must
be in the list for the file to be processed. -- >
< Switches >
< Switch minSwVer ="3.2.10"> 708TX Switch > -- If the minSwVer attribute is present, it
overrides the minSwVer attribute of
SystemConfiguration. --
>
< Switch > 7506GX2 Switch >
Switches >
-- ______________________________________________________________________________________ -- >
-- Administration -- >
< Administration >
< SwitchName > myname SwitchName > -- optional -- > --255 character limit-- >
< SwitchLocation > mylocation SwitchLocation > -- optional -- > --255 character limit-- >
< SwitchContact > mycontact SwitchContact > -- optional -- > --255 character limit-- >
Administration >
-- ______________________________________________________________________________________ -- >
-- IP configuration -- >
< IPConfiguration >
< Mode > static OR dhcp Mode > -- Mode must be static or dhcp -- >
-- If dhcp mode, these elements are the "Fallback" Address, Subnet, and Gateway.
Note: For an IP address of 192.168.1.201, there is no fallback address. -- >
-- All IP addresses have a 15 character limit (xxx.xxx.xxx.xxx) -- >
< Address > 192.168.1.222 Address > -- 15 character limit -- >
< Subnet > 255.255.255.0 Subnet > -- 15 character limit -- >
< Gateway > 192.168.1.1 Gateway > -- 15 character limit -- >
-- If dhcp mode, this is the dhcp client id -- >
< ClientID >
-- Use one of the elements (MACAddress, SwitchName, OtherText, OtherHex).
MACAddress and SwitchName use current switch values. -- >
< MACAddress />
< SwitchName />
< OtherText > myClientID OtherText > -- 255 character limit -- >
< OtherHex > 0102de03ad00be09ef OtherHex > -- 255*2 character limit -- >
ClientID >