N-Tron 710FX2 - Manual (Page 118)

(Revised 2012-05-01 Page 118 of 170
Configuration – Save or Reset
The Configuration section of web management gives an administrator the ability to save a running
configuration into the NVRAM. This step is needed in order for the switch to remember any changes after a
power cycle.
The “Save” button will save all current changes to the configuration for use after the next power cycle.
The “Reset” button will discard all unsaved changes, reset the switch and load the most recently saved
configuration settings.
The “Factory” button will reload N-Tron’s factory default configuration settings. Doing so will reconfigure
the 710FX2 Series switch to factory defaults. In many cases it is desirable to restore factory defaults but
retain certain settings. Checkboxes are provided to select the desired behavior. Note that if no
Configuration Device is present, that is presented.