N-Tron 710FX2 - Manual (Page 103)

(Revised 2012-05-01 Page 103 of 170
N-Link – Status
The Status tab under the N-Link category will display the N-Link status.
If the switch is an N-Link Master or Slave, the following switch status and partner status information will be
shown. Fields with a red background designate a fault condition.
State: Current N-Link mode of switch.
Control Port: The port being used to convey control information. There must be a
direct link between the Master and Slave Control ports. Use of media
converters or other switches is not supported.
Partner Port: The port being used for normal communication between the N-Link
Master and N-Link Slave switch. There must be a direct link between
the Master and Slave Partner ports. Use of media converters or other
switches is not supported. This port will be detected automatically.
Coupler Port: The port being used to establish a redundant path for ethernet data
transmission.
Coupler Port State: Blocking, Forwarding.
Status: No errors will show "OK", otherwise a description of the Faults
detected.
N-Link Partner Information
State: Current N-Link mode of switch.
MAC: The MAC Address of the N-Link Partner switch.
Coupler Port State: Blocking, Forwarding.
Status: No errors will show "OK", otherwise a description of the Faults
detected.
If switch is an N-Link Auto Configure and not a Slave, the Coupler port, if known, will be shown.
N-Link State: Current N-Link mode of switch.
Coupler Port: The port used to establish a redundant path for ethernet data
transmission. This port will be detected automatically.
Below is an example of N-Link Status from a switch in defaults (N-Link Auto Configure) that is not an
N-Link Master and has not become an N-Link Slave or an N-Link Coupler: