National Instruments 5411 User Manual

Page 80

Index

DAQArb 5411 User Manual

I-2

phase-locked loops, 4-22 to 4-24

architecture (figure), 4-22
master/slave operation, 4-23 to 4-24

RTSI trigger lines, 4-27 to 4-28
triggering, 4-11 to 4-16

burst trigger mode, 4-15 to 4-16
continuous trigger mode,

4-13 to 4-14

modes of operation, 4-12 to 4-16
single trigger mode, 4-12 to 4-13
stepped trigger mode, 4-14 to 4-15
trigger sources, 4-11 to 4-12

update rate, 4-3
waveform generation, 4-2 to 4-3

buffer size, 4-6
buffers

minimum buffer size and resolution, 4-5
waveform buffer, 4-5

bulletin board support, C-1
burst trigger mode

Arb mode, 4-15 to 4-16
DDS mode, 4-16

bus interface specifications, A-4

cables

part numbers for recommended

cables, 1-5

requirements for getting started, 1-2

calibration, 4-28
clock specifications

external clock reference input, A-6
internal clock, A-6

configuration. See installation and

configuration.

connectors. See I/O connector; SHC50-68

50-pin cable connector.

continuous trigger mode

Arb mode, 4-14
DDS mode, 4-14
overview, 4-13

customer communication, x, C-1 to C-2

DAQArb 5411. See also Arb operation.

block diagram, 4-1
cabling, 1-5
features, 1-1 to 1-2
locking to National Instruments cards

over RTSI bus (note), 3-3

optional equipment, 1-5
requirements for getting started, 1-2
software programming choices, 1-3 to 1-4

National Instruments application

software, 1-3 to 1-4

NI-DAQ driver software, 1-4

unpacking, 1-6

DDS mode. See direct digital synthesis (DDS)

mode.

DGND signal (table), 3-6
Dig Out connector, 3-4 to 3-5

pin assignments (figure), 3-5
signal descriptions (table), 3-6

digital pattern generation, 4-25 to 4-27

data path (figure), 4-26
timing (figure), 4-26

digital pattern output specifications, A-5
digital trigger specifications, A-4
direct digital synthesis (DDS) mode,

4-8 to 4-11

burst trigger mode, 4-16
continuous trigger mode, 4-14
DDS building blocks (figure), 4-9
definition, 4-8