National Instruments Measure Data Acquisition User Manual
Page 61
Appendix B Error Codes
Measure Data Acquisition User Manual
B-8
© National Instruments Corporation
group.
-10413
groupAssignErr
A group is already assigned, or the
specified line or channel is already
assigned to a group.
-10414
reservedPinErr
The selected signal requires a pin that is
reserved and configured only by
NI-DAQ. You cannot configure this pin
yourself.
-10416
DSPDataPathBusyError
Either DAQ or WFM can use a PC
memory buffer, but not both at the same
time.
-10417
SCXIModuleNotSupportedErr
or
At least one of the SCXI modules
specified is not supported for the
operation.
-10344
chassisSynchedError
The Remote SCXI unit is not
synchronized with the host. Reset the
chassis again to resynchronize it with the
host.
-10345
chassisMemAllocError
The required amount of memory cannot
be allocated on the Remote SCXI unit for
the specified operation.
-10346
badPacketError
The packet received by the Remote SCXI
unit is invalid. Check your serial port
cable connections.
-10347
chassisCommunicationError
There was an error in sending a packet to
the remote chassis. Check your serial
port cable connections.
-10348
waitingForReprogError
The Remote SCXI unit is in
reprogramming mode and is waiting for
reprogramming commands from the host
(NI-DAQ Configuration Utility).
-10349
SCXIModuleTypeConflictErr
or
The module ID read from the SCXI
module conflicts with the configured
module type.
-10440
sysOwnedRsrcErr
The specified resource is owned by the
driver and cannot be accessed or
modified by the user.