National Instruments Measure Data Acquisition - Manual (Page 41)

Chapter 5 Analog Output Reference
© National Instruments Corporation 5-3 Measure Data Acquisition User Manual
Note: If you want to generate waveforms on more than one channel, each channel
must be added separately to the channel list. Also, Measure requires that all
channels have the same number of voltage values to generate. If the range of
data for one channel is larger than for another channel in the scan list, the
shorter range of data is padded with the value 0 when Measure generates the
waveforms.
Advanced Configuration
For most of your tasks, you do not need to use the Advanced Analog
Output Configuration dialog box, shown in Figure 5-2. With this dialog
box, you may change the output range of your device by specifying
new high and low limits or you may specify a current channel type, if
your device supports it. Refer to Table 5-2 for detailed information.
Figure 5-2. Advanced Analog Output Configuration Dialog Box