Nortel Networks CALLPILOT 555-7101-215 - Manual (Page 45)

May 2003 Installing the server and connecting the peripheral devices
Part 2: 702t Server Hardware Installation 45
To connect the mouse, keyboard, and monitor to the server
1 Place the monitor, keyboard, and mouse in the same location as the
server.
2 Plug the keyboard and mouse into the appropriate PS/2 connectors on
the chassis rear panel. See the diagram on page 44.
3 Plug in the monitor connector. Tighten the screws on the connector.
4 Connect the power cord to the monitor, and plug the other end into a wall
receptacle or power bar.
5 Turn on the monitor.
To connect the modem to the server
1 Ensure that the modem’s AC power cord is not plugged in.
2 Connect the large 25-pin male connector to the back of the modem.
Tighten the connector screws.
3 Connect the 9-pin female connector to COM1 at the rear of the server.
Tighten the connector screws.
4 Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
5 Connect the other end of the telephone cable to the RJ-11 jack in the
wall.
6 Connect the power cord to the modem, and plug the other end into a wall
receptacle or power bar.
7 Turn on the modem.
What’s next?
Continue with “Connecting the server to the ELAN” on page 46.