Nortel Networks CALLPILOT 555-7101-215 - Manual (Page 29)

May 2003 Preinstallation requirements
Part 2: 702t Server Hardware Installation 29
Unpacking the 702t server
Introduction
Follow this procedure to unpack the server and peripherals.
To unpack the equipment
1 Carefully open the cardboard carton containing the server.
2 Remove the server from the carton and set it on the floor.
3 Carefully open the cartons containing the monitor, keyboard, mouse,
modem, and ELAN hub (if supplied), and set the peripherals aside.
4 Put all manuals, CD-ROMs, operating system disks, any disks for
peripherals, and the Windows NT emergency repair disk in a safe place.
5 Save all packing materials and cartons in case you must return any
equipment to the carrier.
.
WARNING
Risk of personal injury
The 702t CallPilot server weighs approximately 17 kg (38 lb)
as shipped from manufacturing. To prevent personal injury, ask
someone to help you unpack and position the server.
ATTENTION
As you unpack each item, check it off against the
packing list, as well as against the following checklists
provided in Part 1 of the CallPilot Installation and
Configuration binder:
„ “CallPilot software media and documentation
checklist”
„ “CallPilot server hardware checklist”