Nortel Networks 2000 - Manual (Page 16)

Chapter 2 Hardware Installation and Initial Configuration
Materials Required
8 Application Gateway Hardware Installation Guide
Materials Required
To install the Application Gateway, obtain the following items:
1.
The Application Gateway and its installation CD-ROM.
Note
Save the packaging container and packing materials in case you
must reship the product.
2.
The power cable for the Application Gateway. Check that the power
cord is the exact type required in the host region. Do not modify or use
the supplied AC power cord if it is not the correct type.
3.
The serial cable for the Application Gateway. Alternatively, a
crossover cable.
4.
The CAT5 cables for networking.
Obtained the following:
•
screwdrivers
•
an ECOS 1023 POW-R-MATE or similar type of
multimeter
•
appropriate cable terminating tools
•
a computer to be connected directly to the Application
Gateway by a DTE—DTE null modem cable, with a
teletype terminal (ANSI-W emulation, serial port,
19 200 bps) for the Application Gateway. Alternatively,
a crossover cable and PC.
Determined the network location for the Application
Gateway? For information, refer to the Application Gateway
Network Integration Guide.
Completed the Application Gateway Pre-Installation
Checklist?
Table 1 Readiness checklist (Sheet 2 of 2)
Have you: ✓