Nautique SPORT NAUTIQUE 216 - Manual (Page 87)

4-18
Speedometer Calibration
The analog speedometer displays the speed of the boat through the
water. The speedometer is calibrated at the factory however,
significant variations can occur due to changes in location.
Therefore, the speedometer can be easily calibrated to a known
reference such as a radar gun, measured course, or GPS. The LCD
will display:
When the unit is operating in normal mode (i.e. pitot status
information on the LCD), push and release M to put the
speedometer in the calibration mode. Push and hold M down for
at least two seconds, the LCD will show “AdJUST.”
Run the boat at a constant 30 MPH as measured by the GPS, radar,
or closed coarse. Adjust the speedometer pointer by pressing
▲ and
▼ until the speedometer matches the known speed.
When finished, press M to exit the adjustment screen. The operator
has the option of saving or canceling the adjustment procedure.
The options can be selected using
▲ and ▼. To save the calibration
setting, press and hold M for two seconds when the display shows
“SAVE.”
Calibration Display
CORC117
Calibration Display
CORC116
Section 4
Correct Craft, Inc.
Nautique Sport Sec 4.qxd 11/19/04 4:02 PM Page 18