Nautique SPORT NAUTIQUE 216 - Manual (Page 159)

8-16
Rudder Remote Lube Fitting (if equipped)
The remote lube fitting allows for easy access to lubricating the
rudder. The remote lube fitting is located in the stern storage area,
underneath the shroud. Use a quality marine grease and gun.
Connect the grease gun to the fitting and apply a light pressure to
the gun until you feel a slight resistance.
V-Drive
Oil Level Inspection
NOTICE
Check the oil with the boat level and the engine OFF.
Remove the oil level gauge (A). The oil level should be between
“H”
and “L” marks on the gauge. Verify the oil level with the gauge
fully inserted into the V-Drive housing. DO NOT overfill. Use fresh
SAE 30 motor oil only. To add or fill, unscrew the breather cap (B)
and add or fill through the breather cap elbow (C).
RV-10 RV26D RV36D RV-40D RV48D RV50D
Approximate 1 pint 2 pints 3 pints 4 pints 4 pints 5 pints
oil capacity (.47 l) (.95 l) (1.42 l (1.89 l) (1.89 l) (2.37 l)
Reinstall the gauge and the breather cap. Run the engine and stop
the engine. Allow the boat to rest momentarily and then verify oil
level. Add oil if necessary.
(“L”)
(“H”)
CORC154
A
Section 8
Correct Craft, Inc.
Nautique Sport Sec 8.qxd 11/19/04 4:11 PM Page 8-16