Nautique SPORT NAUTIQUE 216 - Manual (Page 115)

4-46
Section 4
Correct Craft, Inc.
Correct Craft Cruise - Operating Instructions
Turn system ON (light blinks slowly, indicating system is activated)
Drive to desired speed, press ENGAGE and the system takes control
of the throttle (light will stay on steady).
Pull back on the throttle to disengage the system (light will blink
rapidly, indicating RESUME function is ready).
Accelerate again and the system resumes control at the last speed
used.
RESUME key feature will recall the last speed used even if the
system was shut off, completely powered down or the DISENGAGE
function was used. To go back to the previous speed at any time,
press RESUME.
Press RESUME and ENGAGE together and the system will
DISENGAGE, but remain activated (light will blink slowly). This
feature may be used when the operator wishes to go to manual
driving. To return to the last speed, press the RESUME. If the speed
is to be changed, drive to that speed and press ENGAGE.
INCREASE / DECREASE key can be pressed when the system is
engaged to change speed in 25 RPM increments to fine tune the
speed.
User tips:
Always return to NEUTRAL and let the engine idle for two or three
seconds before turning the engine OFF.
NOTICE
The servo knob cannot be moved if the engine is running.
Regularly check the set screw on the side of the black knob for
tightness.
The boat speed will decrease in sharp turns. If you are towing
skiers, you may wish to manually increase the throttle or use the
DISENGAGE feature to maintain speed in sharp turns.
When towing wakeboarders, accelerate slightly past desired speed
prior to engaging the speed control.
Nautique Sport Sec 4.qxd 11/19/04 4:02 PM Page 46